Seiko I Infotech LP-1030 User's Guide download pdf (Page 80)

2-38

When feeding the cut paper into the manual paper feed inlet, follow the

procedure below (position the cut paper in the center of the manual paper

feed inlet).

When plotting on the fixed form paper, set the paper as shown below (the

paper input direction varies depending on the fixed form paper size).

When plotting at the actual length or expanded size of a fixed form, load

the paper as shown below (paper should be always set lengthways).

After the cut paper is properly fed into the manual paper feed inlet, the

device pulls the paper into it.

Notes

◆When the paper is manually fed, printing is made only on one

sheet of paper even if the number of prints is set to more

than two.

◆Even if the correct size cut paper is not used, printing takes

place when cut paper is fed into the device. In this case, the

drawing may be missing in part.

Set the paper (sideways) in case of:

A4 fixed form cut paper of A series

A fixed form cut paper of 9×12 series

B3 fixed form cut paper of DIN series

A fixed form cut paper of 8.5×11 series

Manual paper feed inlet

Cut paper

Set other fixed form cut paper

(lengthways)

Manual paper feed inlet

Cut paper

Example of A3 width cut paper

Manual paper feed inlet

Cut paper

Downloaded From ManualsPrinter.com Manuals

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 289 290

No comments

Seiko I Infotech LP-1030 User's Guide Page 80